Detailed Product Attribute Condition : New
SMH High Capacity Hydraulic Cone Crusher
(1) Introduction
SMH series hydraulic cone crusher get to world advanced level, is designed and made through absorbing world crushing technology. it is widely use in metallurgical,architectural,water and electricity,traffic,chemical,architectural material industries, it is suitable for crushing varies of mid hard and above mid hard ores and rocks.
(2) Technical Character
1Reasonable construction advanced crushing principle and technical specification, reliable work and low cost.
2 Strong crushing ability, high efficiency productivity, high capacity.
3 Hydraulic system is reliable provide safe overload protection.
4 Types of crushing chamber are for wide range of product size requirement.
5 Use hydraulic adjustment and hydraulic clean chamber setting, much increase automation.
(3) Technology Data
Note: The capacity is total tons per hour passing through crusher at open circuit when crushing mid-hard material and bulk density with 1.6×103Kg/m3 capacities are relative to physical character and type of feeding, feeding size and composition and so on.
(4) Enhance Crusher Capacity and Character
The capacity charts is for properly using SMH cone crusher and get to its capacity. Crusher is component of mining production line, so it’s character result from feeder, conveyor, screen, electric motor, drive part, surge bin. Noticing follow factors can enhance crusher capacity and character.
1 According on crushing material to select chamber
2 Feed rate is controlled.
3 Feed is average distribute at 360° crushing chamber.
4 Automation controls
5 Enough crusher discharge area.
6 Capacity of discharge conveyor is more than cone crusher
7 Use right scalping and closed circuit screens
(5) Below factors will lower the capacity
1 Fine material of feeding is more than 10% of capacity
2 Containing sticky material in feed
3 Lack of feed control
4 Feed is not averagely distributed around crushing chamber
5 Horsepower is not getting too recommended
6 Discharge area, discharge conveyor, scalper and screen are not sufficient
7 Insufficient crusher discharge area
8 Feed material is too hard or too tough
(6) Product Gradation Table (% passing through square mesh depending on the setting)
Note: The gradation shown are depend on the feed gradation, the crushing chamber, the material density, the material mud content, its moisture and its crushability.
(7) Wear Parts
(8) The Specifications We Should Know for Quoting
1 What is the raw material /processing stone?
2 The max input size?
3 Output size?
4 Output capacity?
